Nintendo CP Carriage Bolts

[STEVESPEEZE]

Well, I have a control panel. It, has no carriage bolts (the carriage bolts are used to hold down the cpo to the wood). Does anyone know where I can find these? 

I have a set.

[UnwoundS3GA]

Well, I have a control panel. It, has no carriage bolts (the carriage bolts are used to hold down the cpo to the wood). Does anyone know where I can find these? 

mikesarcade.com has them. They are not cheap. But, he has them.

It dose not look like there on his site, or for sale anymore. I have looked before too, never have saw them. 

Here:

http://thearcadeboneyard.com/new_arcade_parts/new_hardware_hinges_locks.php

Hey John, Just got my carriage bolts in the mail today. I tried to put them in my control panel, and they wouldn't fit.  Do you know anywhere else where you can buy them?

[John's Arcade]

Serious? Did you contact him???

Sent from my SAMSUNG-SGH-I317 using Tapatalk

[UnwoundS3GA]

Serious? Did you contact him???

Sent from my SAMSUNG-SGH-I317 using Tapatalk

We contacted him for Shipping & Paying arrangements only. The carriage bolts we bought were labeled "4 MM. X 35 MM ( 1 5/8 ) Carriage Bolts & Nuts These Are Good For Use On Nintendo Coin Doors & Control Panels (10 Pack) $3.99" on his site. Here's a picture of the carriage bolts.

[John's Arcade]

That doesn't look like what you got!

Measure them.

4MM. X 35 MM ( 1 5/8 ) Carriage Bolts & Nuts These Are Good For Use On Nintendo Coin Doors & Control Panels (10 Pack) $3.99


These look the same to you?!?!

[UnwoundS3GA]

The carriage bolt goes all the way in until, It reaches the square neck right at the head, and that stops it from going all the way down in the hole.

[UnwoundS3GA]

Here's some better quality photos. As you can see, the square neck does not fit all the way down in the CP.

[Etienne MacGyver]

they look M5 to me, but i could be wrong..

did you measure the diameter ?

[John's Arcade]

Did  you contact Arcade Boneyard?!? I would show him your photo and see what he has to say!