Anyone have a Galaga Mini?

[MagicMarc-er]

Can't seem to get any help on KLOV so, hopefully, someone here can help.

Could anyone please take a pic inside their Galaga cabaret (or full size since it is probably the same) at the wiring where the 6 pins from the monitor chassis plug into the video board?  Would also like a pic of the same wires where they plug into the chassis. 

I've been having trouble understanding one thing on the schematics and those two pics would really help.

[iankellogg]

Not sure what you need the pic for. The video goes out of the 6 pin header of the PCB and goes right into the monitor with separate cable than the wire harness.

[MagicMarc-er]

Ian - I am trying to understand how to handle the yellow wire (pin 5 I think on the schematic) is listed as "Yel + Shield Gnd".  It sounds like I'm supposed to tie the yellow wire to a ground wire after it leaves the chassis but it doesn't show up that way on the drawing.  Pull up the Galaga schematic and see if you can tell what I mean.  Any help would be great.

Not sure what you need the pic for. The video goes out of the 6 pin header of the PCB and goes right into the monitor with separate cable than the wire harness.

[iankellogg]

Pin 5 just goes to the ground pin on the monitor input header

[MagicMarc-er]

Thanks, Ian.  I guess I was over thinking it a bit.

[VertexGuy]

Not sure what you need the pic for. The video goes out of the 6 pin header of the PCB and goes right into the monitor with separate cable than the wire harness.

Exactly what he said,, you can also go by a ms pac mini.. they are same