Monitor Adjustment

[Vis3c]

Hey Guys

Today i wanted to adjust my monitor a little bit. but i noticed that this little thing (pic. 1) doesnt work.
so i adjusted it in the back of the machine. it bothers me that this little thing under the control pannel doesnt work (i think its not wired).

can somebody tell me how to wire it?
picture 2. is in the back of the machine, just if you need to see wires or something.

1.
2.

[VertexGuy]

if its unhooked, its unhooked for a reason..
that adjuster board may have went to the monitor that was in the machine prior to the one you are using now.

[iankellogg]

That green board looks like it was from a wells monitor. So it isn't much use to you anymore

[VertexGuy]

yeah the remote board. 

[Shipwreck]

I had that remote board on my Neo Geo which had a K7000 in it. It has a ribbon cable that connects to the chassis where those adjustments are.