Wells Gardner K7100?

[xcaliber]

I'm restoring a MK1 and was going to order a cap kit for the monitor, but I'm confused as to which chassis I have. There is a sticker near the fly back that reads Y3OK7191-000 and then there is another sticker on the side of the chassis that reads WG673288. I believe it is a 7100 series and wanted to make sure by asking you guys. I have never done a cap kit and I want to at least get the right kit. Also, I have pic of the bottom of the monitor PCB. I looks as if it shorted. If it shorted is it repairable or should I just get another?

[P-feif]

Well I'm no good at indentifying monitors but I bet the guys here that can would like a picture of the whole thing.

That looks repairable to me.

[xcaliber]

[VertexGuy]

I'm restoring a MK1 and was going to order a cap kit for the monitor, but I'm confused as to which chassis I have. There is a sticker near the fly back that reads Y3OK7191-000 and then there is another sticker on the side of the chassis that reads WG673288. I believe it is a 7100 series and wanted to make sure by asking you guys. I have never done a cap kit and I want to at least get the right kit. Also, I have pic of the bottom of the monitor PCB. I looks as if it shorted. If it shorted is it repairable or should I just get another?

you can/somebody/it can be fixed.

[amoore2600]

The Chassis is a P538 = 25K7193

Check the Bill of Materials (BOM) Reference below

https://www.wellsgardner.com/service/bom_reference.asp