Sanyo EZ 20 13" in DK Cocktail

[alby13]

Seriously....what the falfieaifeljfalejfael!  New B+ pot, New B+ filter, New flyback, new HOT, new caps and I am STILL getting 130+V on the B+ and it won't adjust!!!!!!!!!!!!!!!!!!!!!!!!!!!

it sounds like you manufactured a monitor geeze so much work... is it worth it? how much have the parts cost so far?

[mrdude]

• deluxe cap kit and flyback - $37
• (2) HOT because I killed the first one - $10
• B+ Pot & B+ Filter cap shipped - $7
• voltage regulator & q901 transistor shipped - $18.25
• Other shipping charges - $18?
• Grand total - $90.25....

I am about to go put the last parts in...it better work.

[mrdude]

So....all these new parts and I still can't adjust it under 130v. In fact...if I take out the B+ pot and turn it on I still get 130v....shouldn't I get 0v?

[mrdude]

New chip on the way. Here is the current video update: https://www.youtube.com/watch?v=q60maA4DP64

[Xeno_Dragon]

Did you end up getting this working with the new ic401.

[yocke]

Is the board working?  RGB are connected?
Do the tube get a glow?

[mrdude]

So I have still not gotten this thing working despite replacing IC401, IC601, etc

I have tried a total of 3 IC601s (original, new, and from parts board). I brought it to a weekly arcade gathering for another set of eyes and it appears as if everything is working as it should, but it's not. I left with a parts chassis to try things on. I may try to see if I can get the parts chassis to work, but that's for a 19" monitor and not a 13". I just don't know what the subtle differences are other than the adjustments knobs for the picture and volume aren't on the chassis and are on a remote board instead.

http://youtu.be/RuO2rFrJXwU?list=PLbHiYDImGdzCvhVYmfFw_2AlTjtyc6wVV