Thanks they took a while to make I have even finished up a design for Frogger that fits the Coin Controls mech. It works but the original C-clip at the top that holds it in pinches the plastic just a little too hard. The bottom flares open just a little but coins still travel through. I'm just worried that over time it might warp the plastic so I need to put a binder clip on the bottom before I totally reassemble the mech.

I have created some 3D printed coin mechs you can use any coin you want up to a Chuck E Cheese Sized token. $8 each and I'm tossing in a choice of one arcade decal I made for every 2 sold.

I have 4 stud mechs that work on Midway doors, Neo geo Red cabinet and other games that use coin mechs that use 4 studs. Also works on Owl Eye doors.

I have 2 stud mech that work on Atari System 1 and Atari Asteroids Deluxe door style doors.

This Was Sold (well Traded).

Works 100% new t-molding, locks, monitor capped, cabinet cleaned, has manual. $675 located in Wallingford PA 19086

Rare game has a weird backstory to it.



First level


2nd level

They all have 4-way plates. Here are some pictures Of the measurements I'm fairly sure their the correct DK size.

#8 was sold

Totally taken apart, cleaned and rebuilt. Bran new spring and I put a fresh set screw in the joystick ball tops. I tested all the switches with my multimeter to make sure they worked. Joysticks numbered 1-11 pick which ever one you want if its still available. $65 + shipping

Have an 8-way Nintendo Joystick I just cleaned an rebuilt.  I took the entire thing apart cleaned it, oiled it and replaced the spring with a new one. I also checked all the switches with the multimeter and they all test good. Also replaced the yellowed sleeve under the ball with a new one. The thing looks practically new.

This should be the style used on a red tent /playchoice

Asking  ̶$̶7̶5̶ ̶s̶h̶i̶p̶p̶e̶d̶.̶  Now $68 shipped