|
Title: Daughter boards, UGH!! Post by: Spyhunter on April 05, 2013, 10:11:13 am Ok, so I just got my red tent system shipped to me only to find the daughter board fell off into the bottom of the cabinet!! What a terrible design!! No locking mechanism what so ever, just "sits" on the board in a verticle position waiting to fall off...
So I have to wiggle it to get SMB to work on the main side, and Goonies on the daughter board just doesn't work. Some boot ups it will show GOONIES ROM OK on the screen and never change, other boot ups, the screen is completely blank, HELP!! SH Title: Re: Daughter boards, UGH!! Post by: atariforever2002 on April 05, 2013, 02:30:27 pm Duct tape is my friend.
Title: Re: Daughter boards, UGH!! Post by: Spyhunter on April 07, 2013, 05:31:02 pm Aha, SMB was put into the sub, not main side, this looks to be the problem!
Title: Re: Daughter boards, UGH!! Post by: John's Arcade on April 08, 2013, 02:18:19 pm Ok, so I just got my red tent system shipped to me only to find the daughter board fell off into the bottom of the cabinet!! What a terrible design!! No locking mechanism what so ever, just "sits" on the board in a verticle position waiting to fall off... So I have to wiggle it to get SMB to work on the main side, and Goonies on the daughter board just doesn't work. Some boot ups it will show GOONIES ROM OK on the screen and never change, other boot ups, the screen is completely blank, HELP!! SH Pull the board out and reseat everything. When the daughter board is in it really doesn't fall off too easily unless it's not in all the way. Title: Re: Daughter boards, UGH!! Post by: Spyhunter on April 16, 2013, 11:23:24 am I've reseated it dozens of times, the pins really do just sit in the chip holders... It's not like the pins go through the board to the other side or anything... there's only a little bit of travel in there...
SH Title: Re: Daughter boards, UGH!! Post by: Joe3693 on April 17, 2013, 02:51:30 am You either need to push harder or get a different board. If you put a regular cpu or ppu in the sockets do they just fall out? If they do you need a new main board. If they click in and stay, then you are just not pushing hard enough. With my castlevania card i took the cpu and ppu off so i could really push down. Just when you think it is going to break it might be in lol.
Hope that helps |