|
Title: Monitor Adjustment Post by: Vis3c on May 29, 2015, 01:01:37 pm Hey Guys
Today i wanted to adjust my monitor a little bit. but i noticed that this little thing (pic. 1) doesnt work. so i adjusted it in the back of the machine. it bothers me that this little thing under the control pannel doesnt work (i think its not wired). can somebody tell me how to wire it? picture 2. is in the back of the machine, just if you need to see wires or something. 1.(http://i.imgur.com/O5KAKqc.jpg) 2.(http://i.imgur.com/KF80tOi.jpg) Title: Re: Monitor Adjustment Post by: VertexGuy on May 31, 2015, 05:54:09 pm if its unhooked, its unhooked for a reason..
that adjuster board may have went to the monitor that was in the machine prior to the one you are using now. Title: Re: Monitor Adjustment Post by: iankellogg on June 01, 2015, 09:44:32 am That green board looks like it was from a wells monitor. So it isn't much use to you anymore
Title: Re: Monitor Adjustment Post by: VertexGuy on June 01, 2015, 10:13:53 am yeah the remote board.
Title: Re: Monitor Adjustment Post by: Shipwreck on June 01, 2015, 11:36:46 am I had that remote board on my Neo Geo which had a K7000 in it. It has a ribbon cable that connects to the chassis where those adjustments are.
|