|
Title: TE Connectivity VS Molex Question Post by: OriginalTHK on September 10, 2014, 02:46:24 pm Ok so I bought some TE parts and I though they were interchangeable? Was I right to assume this? Or did they "f" up my order????
I attached a pic. I wanted a 9 pin molex connector and they look way SMALLER then the molex. (http://s16.postimg.org/agec8ls79/TEvs_MOLEX.jpg) Title: Re: TE Connectivity VS Molex Question Post by: iankellogg on September 11, 2014, 07:13:25 am .250 centerline is compatable between molex versions of the same connector. I feel bad now since I couldn't quite see the connector in photos before. I'll have to look at which connector that is but i think its .084 series after looking at it.
Title: Re: TE Connectivity VS Molex Question Post by: iankellogg on September 11, 2014, 07:29:49 am https://www.greatplainselectronics.com/products.asp?cat=90
this is the series of connector at probably one of the cheapest connector places around. Title: Re: TE Connectivity VS Molex Question Post by: OriginalTHK on September 11, 2014, 01:18:35 pm It looks like the TE parts might work? Will I be able to just cut off the connectors and replace them with the new ones? That should still work right?
That new site just has the one type of 9 pin. Does it have the other? I am so confused now.... Title: Re: TE Connectivity VS Molex Question Post by: OriginalTHK on September 11, 2014, 01:27:33 pm 50-84-1090 Connector, Plug, 9 Pin, 0.084" $4.50
50-84-2090 Connector, Receptacle, 9 Pin, 0.084" $5.50 with shipping Grand Total: $13.58 Are these the right ones I need this time????? Total is for 10 of each UPDATE*** Ok I pulled the trigger and ordered them, I am PRAYING these are the right ones I need this time |