|
Title: Terminator 2 Arcade Keeps Blowing a Fuse Post by: lacerta1974 on September 02, 2014, 10:31:45 pm I just picked up a T2 arcade. The guns aren't working...I can hear the firing sound on the screen but don't see any cross hairs. I was doing a bit of reading and decided to check the fuses on the coil lamp assembly board. I found that the fuse at the F3 position was blown. I looked up in the manual and it showed a 1A, FB, 250V fuse. So I replaced the fuse. Now when I went in to the gun calibration screen for the first little bit I saw the x/y coordinates weren't just jumping all over the place randomly as they were before when the fuse was blown. However part way through the calibration it started back up. I shut it off, checked the fuse and it was blown again. I checked the 5V on the power supply and it was reading 5V. I tried one more time with the same results. Anyone work on these before? I'm not sure how to proceed from this point. Any recommendations would be appreciated. Thanks.
Title: Re: Terminator 2 Arcade Keeps Blowing a Fuse Post by: iankellogg on September 04, 2014, 08:48:41 am I am not very familiar with this game but I would check the coils in the gun for shorts and maybe just remove them out of the circuit for now. I am sure the wiring diagram in the manual will be able to tell you whats connected to that fuse.
|